NSE 7 Network Security Architect NSE7_SDW-7.0 Dumps | Updated Feb 04, 2024 - VCE4Plus
Master 2024 Latest The Questions NSE 7 Network Security Architect and Pass NSE7_SDW-7.0 Real Exam!
NEW QUESTION # 29
Refer to the exhibit.
The exhibit shows the SD-WAN rule status and configuration.
Based on the exhibit, which change in the measured packet loss will make T_INET_1_0 the new preferred member?
- A. When T_INET_0_0 has 4% packet loss.
- B. When T_INET_1_0 has 4% packet loss.
- C. When T_INET_0_0 has 12% packet loss.
- D. When all three members have the same packet loss.
Answer: D
NEW QUESTION # 30
Refer to the exhibit.
Which two SD-WAN template member settings support the use of FortiManager meta fields? (Choose two.)
- A. Priority
- B. Gateway IP
- C. Cost
- D. Interface member
Answer: B,D
NEW QUESTION # 31
Refer to the exhibit.
An administrator is troubleshooting SD-WAN on FortiGate. A device behind branch1_fgt generates traffic to the 10.0.0.0/8 network. The administrator expects the traffic to match SD-WAN rule ID 1 and be routed over T_INET_0_0. However, the traffic is routed over T_INET_1_0.
Based on the output shown in the exhibit, which two reasons can cause the observed behavior? (Choose two.)
- A. T_INET_1_0 has a lower route priority value (higher priority) than T_INET_0_0.
- B. T_INET_0_0 does not have a valid route to the destination.
- C. The traffic matches a regular policy route configured with T_INET_1_0 as the outgoing device.
- D. T_INET_1_0 has a higher member configuration priority than T_INET_0_0.
Answer: B,C
Explanation:
https://community.fortinet.com/t5/FortiGate/Technical-Tip-Assigning-Priority-to-SD-WAN-Members-for-Default/ta-p/230911
NEW QUESTION # 32
Refer to the exhibits.
An administrator is testing application steering in SD-WAN. Before generating test traffic, the administrator collected the information shown in exhibit A.
After generating GoToMeeting test traffic, the administrator examined the respective traffic log on FortiAnalyzer, which is shown in exhibit B.
The administrator noticed that the traffic matched the implicit SD-WAN rule, but they expected the traffic to match rule ID 1.
Which two reasons explain why the traffic matched the implicit SD-WAN rule? (Choose two.)
- A. The session 3-tuple did not match any of the existing entries in the ISDB application cache.
- B. Full SSL inspection is not enabled on the matching firewall policy.
- C. FortiGate did not refresh the routing information on the session after the application was detected.
- D. Port1 and port2 do not have a valid route to the destination.
Answer: B,C
NEW QUESTION # 33
Refer to the exhibits.
Which two statements about the IPsec VPN configuration and the status of the IPsec VPN tunnel are true? (Choose two.)
- A. FortiGate does not install IPsec static routes for remote protected networks in the routing table.
- B. Dead peer detection is disabled.
- C. The phase 1 configuration supports the network-overlay setting.
- D. FortiGate facilitated the negotiation of the T_INET_1_0_0 ADVPN shortcut over T_INET_1_0.
Answer: A,C
NEW QUESTION # 34
Refer to the exhibit.
Which statement about the role of the ADVPN device in handling traffic is true?
- A. This is a spoke that has received a query from a remote hub and has forwarded the response to its hub.
- B. Two hubs, 10.0.1.101 and 10.0.2.101, are receiving and forwarding queries between each other.
- C. Two spokes, 192.2.0.1 and 10.0.2.101, forward their queries to their hubs.
- D. This is a hub that has received a query from a spoke and has forwarded it to another spoke.
Answer: D
NEW QUESTION # 35
Which two statements are true about using SD-WAN to steer local-out traffic? (Choose two.)
- A. By default, local-out traffic does not use SD-WAN.
- B. By default, FortiGate does not check if the selected member has a valid route to the destination.
- C. You must configure each local-out feature individually, to use SD-WAN.
- D. FortiGate does not consider the source address of the packet when matching an SD-WAN rule for local-out traffic.
Answer: A,C
NEW QUESTION # 36
Exhibit.
Which conclusion about the packet debug flow output is correct?
- A. The total number of daily sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured in the traffic shaper, and the packet was dropped.
- B. The number of concurrent sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured in the firewall policy, and the packet was dropped.
- C. The number of concurrent sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured in the traffic shaper, and the packet was dropped.
- D. The packet size exceeded the outgoing interface MTU.
Answer: C
NEW QUESTION # 37
In the default SD-WAN minimum configuration, which two statements are correct when traffic matches the default implicit SD-WAN rule? (Choose two )
- A. Matched traffic failed RPF and was caught by the rule.
- B. An absolute SD-WAN rule was defined and matched traffic.
- C. Traffic has matched none of the FortiGate policy routes.
- D. The FIB lookup resolved interface was the SD-WAN interface.
Answer: C,D
NEW QUESTION # 38
Which two settings can you configure to speed up routing convergence in BGP? (Choose two.)
- A. link-down-failover
- B. update-source
- C. set-route-tag
- D. holdtime-timer
Answer: A,D
NEW QUESTION # 39
What does enabling the exchange-interface-ip setting enable FortiGate devices to exchange?
- A. The IP address of their IPsec interfaces
- B. The tunnel ID of their IPsec interfaces
- C. The gateway address of their IPsec interfaces
- D. The name of their IPsec interfaces
Answer: A
NEW QUESTION # 40
Which diagnostic command can you use to show the member utilization statistics measured by performance SLAs for the last 10 minutes?
- A. diagnose sys sdwan sla-log
- B. diagnose sys sdwan health-check
- C. diagnose sys sdwan log
- D. diagnose sys sdwan intf-sla-log
Answer: A
NEW QUESTION # 41
Refer to the exhibits.
Which conclusion about the packet debug flow output is correct?
- A. The total number of daily sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured in the traffic shaper, and the packet was dropped.
- B. The number of concurrent sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured in the firewall policy, and the packet was dropped.
- C. The number of concurrent sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured in the traffic shaper, and the packet was dropped.
- D. The packet size exceeded the outgoing interface MTU.
Answer: C
Explanation:
In a Per-IP shaper configuration, if an IP address exceeds the configured concurrent session limit, the message "Denied by quota check" appears. SD-WAN 7.0 Study Guide page 287
NEW QUESTION # 42
Which are three key routing principles in SD-WAN? (Choose three.)
- A. FortiGate performs route lookups for new sessions only.
- B. By default, SD-WAN members are skipped if they do not have a valid route to the destination.
- C. By default, SD-WAN rules are skipped if the best route to the destination is not an SD-WAN member.
- D. SD-WAN rules have precedence over ISDB routes.
- E. Regular policy routes have precedence over SD-WAN rules.
Answer: B,C,E
NEW QUESTION # 43
Refer to the exhibit.
Based on the exhibit, which statement about FortiGate re-evaluating traffic is true?
- A. Firewall policy ID 1 has source NAT disabled.
- B. The type of traffic defined and allowed on firewall policy ID 1 is UDP.
- C. FortiGate has terminated the session after a change on policy ID 1.
- D. Changes have been made on firewall policy ID 1 on FortiGate.
Answer: D
NEW QUESTION # 44
Which two statements about SD-WAN central management are true? (Choose two.)
- A. The objects are saved in the ADOM common object database.
- B. It uses templates to configure SD-WAN on managed devices.
- C. It does not support meta fields.
- D. It supports normalized interfaces for SD-WAN member configuration.
Answer: A,B
Explanation:
Normalized interfaces are not supported for SD-WAN templates. You can create multiple SD-WAN zones and add interface members to the SD-WAN zones. You must bind the interface members by name to physical interfaces or VPN interfaces.https://docs.fortinet.com/document/fortigate/7.0.0/sd-wan-new-features/794804/new-sd-wan-template-fmg
NEW QUESTION # 45
Which are two benefits of using CLI templates in FortiManager? (Choose two.)
- A. You can configure FortiManager to sync local configuration changes made on the managed device, to the CLI template.
- B. You can configure advanced CLI settings.
- C. You can configure interfaces as SD-WAN members without having to remove references first.
- D. You can reference meta fields.
Answer: B,D
NEW QUESTION # 46
......
SD-WAN is a rapidly growing segment of the networking industry, and it has become a critical technology for businesses of all sizes. SD-WAN enables organizations to connect their branch offices and remote workers to the corporate network over the internet, providing secure and reliable connectivity. Fortinet's SD-WAN solution is one of the most advanced and comprehensive in the market, and the NSE7_SDW-7.0 Exam is designed to ensure that IT professionals have the skills and knowledge necessary to implement and manage Fortinet's SD-WAN solution effectively.
A fully updated 2024 NSE7_SDW-7.0 Exam Dumps exam guide from training expert VCE4Plus: https://www.vce4plus.com/Fortinet/NSE7_SDW-7.0-valid-vce-dumps.html
Practice To NSE7_SDW-7.0 - VCE4Plus Remarkable Practice On your Fortinet NSE 7 - SD-WAN 7.0 Exam: https://drive.google.com/open?id=1irohm8zrXN0uEaye50tg2k4EbzVIQ6WS